Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster)

DTC    C1282    Center Differential Lock Position Switch

for Preparation Click here


DESCRIPTION

DTC C1282 is stored only in test mode.

DTC Code
DTC Detection Condition
Trouble Area
C1282
Stored during test mode.
  1. Harness or connector
  2. Transfer system
  3. Skid control ECU (brake actuator assembly)

WIRING DIAGRAM


C215183E11


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform calibration (Click here).

1.INSPECT SKID CONTROL ECU (EXI4)
  1. Disconnect the S1 skid control ECU (brake actuator assembly) connector.



    C220649E36
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S1-20 (EXI) - Body ground
    1. Ignition switch ON
    1. Transfer 2WD position
    11 to 14 V
    1. Ignition switch ON
    1. Transfer 4WD position
    Below 1.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU (Brake Actuator Assembly))



NG
Go to step 3
OK


2.CHECK TEST MODE DTC
  1. Switch the vehicle to test mode, perform the 4WD detection switch signal check, and then check that DTC C1282 is cleared (Click here).
    Result 
    Result
    Proceed to
    DTC is not cleared
    A
    DTC is cleared
    B



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - 4 WHEEL DRIVE CONTROL ECU AND 4WD DETECTION SWITCH)
  1. Disconnect the S1 skid control ECU (brake actuator assembly) connector.

  1. Disconnect the F13 4 wheel drive control ECU connector.

  1. Disconnect the A3 4WD detection switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S1-20 (EXI) - F13-26 (ADD)
    Always
    Below 1 Ω
    S1-20 (EXI) - A3-3 (ADD)
    Always
    Below 1 Ω
    S1-20 (EXI) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)