Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

DTC    C1379    Downhill Assist Control Switch Malfunction (Test Mode DTC)

for Preparation Click here


DESCRIPTION

DTC C1379 is cleared when the downhill assist control switch sends a downhill assist control operation signal or when test mode ends.

DTC Code
DTC Detection Condition
Trouble Area
C1379
Stored only during test mode.
  1. Downhill assist control switch
  2. Harness or connector
  3. Skid control ECU (master cylinder solenoid)

WIRING DIAGRAM


C214516E09


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the skid control ECU (master cylinder solenoid), perform calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING TECHSTREAM (DOWNHILL ASSIST CONTROL SW)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.

  1. Check the Data List for proper functioning of the downhill assist control switch.

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Downhill Assist Control SW
    Downhill assist control switch / ON or OFF
    ON: Downhill assist control on
    OFF: Downhill assist control off
    -

    OK:
    The Techstream displays ON or OFF according to downhill assist control switch operation.



NG
Go to step 3
OK


2.CHECK TEST MODE DTC
  1. Perform the Downhill Assist Control Switch Check in the Test Mode Procedure (Click here).

    OK:
    Test mode DTC C1379 is cleared.



NG
REPLACE MASTER CYLINDER SOLENOID (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.INSPECT DOWNHILL ASSIST CONTROL SWITCH
  1. Remove the downhill assist control switch (Click here).



    C237119E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 3
    Switch is not pushed
    10 kΩ or higher
    Switch is pushed
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Downhill Assist Control Switch)



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DOWNHILL ASSIST CONTROL SWITCH/BODY GROUND)
  1. Disconnect the S1 skid control ECU (master cylinder solenoid) connector.

  1. Disconnect the D8 downhill assist control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S1-44 (HDCS) - D8-4
    Always
    Below 1 Ω
    S1-44 (HDCS) - Body ground
    Always
    10 kΩ or higher
    D8-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)