Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE INTAKE AIR SURGE TANK
  1. Remove the intake air surge tank (Click here).



3. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY


    A159687E01
  1. Remove the fuel pipe clamp.

  1. Pinch the tube connector, and then pull the fuel pipe out of the pipe as shown in the illustration.

    NOTICE:
    1. Remove any dirt and foreign objects from the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has the O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Keep the plug free from foreign objects.
    6. Protect the disconnected part by covering it with a plastic bag after disconnecting the fuel tube.
    7. If the fuel tube connector and pipe are stuck, push and pull to release them.



4. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY


    A159686E01
  1. Remove the fuel pipe clamp.

  1. Pinch the tube connector, and then pull the fuel pipe out of the pipe as shown in the illustration.

    NOTICE:
    1. Remove any dirt and foreign objects from the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has the O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Keep the plug free from foreign objects.
    6. Protect the disconnected part by covering it with a plastic bag after disconnecting the fuel tube.
    7. If the fuel tube connector and pipe are stuck, push and pull to release them.



5. REMOVE INTAKE MANIFOLD


    A076533E01
  1. Disconnect the 6 fuel injector connectors.

  1. Remove the 10 bolts, intake manifold and 2 gaskets.



6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


A111701
  1. Disconnect the sensor connector.

  1. Remove the sensor.

  1. Remove the gasket from the sensor.