YAW RATE AND DECELERATION SENSOR > INSTALLATION |
| 1. INSTALL YAW RATE SENSOR |
Connect the sensor connector (labeled A), and then attach the clamp (labeled B) to the hole of the sensor bracket.
Install the yaw rate sensor with the 2 nuts (labeled C).

| 2. INSTALL CENTER FRONT SEAT (for Center Seat) |
Install the center front seat.
![]() |
Connect the connector and install the 4 bolts.
![]() |
Install the center seat cushion carpet.
![]() |
Close the center seat cushion.
| 3. INSTALL CONSOLE BOX ASSEMBLY (for Separate Seat Type) |
Install the console box .
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION |
Perform the yaw rate sensor zero point calibration (Click here).
| 6. CHECK YAW RATE SENSOR SIGNAL |
Check the yaw rate sensor signal (Click here).