DTC P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0125 | Engine coolant temperature (ECT) does not reach closed-loop enabling temperature for 20 minutes (this period varies with engine start ECT) (2 trip detection logic) |
|
| Related DTCs | P0125: Insufficient engine coolant temperature for closed-loop fuel control |
| Required Sensors/Components (Main) | Engine coolant temperature sensor, thermostat, cooling system |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | 58 seconds: Engine coolant temperature at engine start -3.3°C (26°F) or more 105 seconds: Engine coolant temperature at engine start -14.5 to -3.3°C (5.9 to 26°F) 1200 seconds: Engine coolant temperature at engine start -14.5°C (5.9°F) |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0101, P0102, P0103 (Mass Air Flow Meter) P0110, P0112, P0113 (Intake Air Temperature Sensor) P0115, P0117, P0118 (Engine Coolant Temperature Sensor) P0128 (Thermostat) |
| Time until actual engine coolant temperature reaches closed-loop fuel control enabling temperature | 58 seconds: Engine coolant temperature at engine start -3.3°C (26°F) or more 105 seconds: Engine coolant temperature at engine start -14.5 to -3.3°C (5.9 to 26°F) 1200 seconds: Engine coolant temperature at engine start -14.5°C (5.9°F) |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0125 | A |
| P0125 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT WATER INLET WITH THERMOSTAT (THERMOSTAT) |
Remove the water inlet with thermostat (Click here).
Check the valve opening temperature of the thermostat.
Reinstall the water inlet with thermostat (Click here).
|
| ||||
| OK | |
| 3.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.
|
| ||||
| OK | ||
| ||