NAVIGATION SYSTEM (for CrewMax) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.BASIC INSPECTION |
Turn the ignition switch ACC.
Check whether or not the display appears on the navigation receiver.
| Result | Proceed to |
| Display appears | A |
| Display does not appear | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC |
Check for DTCs and note any codes that are output (Click here).
Clear for DTC.
Recheck for DTCs. Based on the DTC output in the first step, try to force output of the navigation system DTC by simulating the operation indicated by the DTC.
| Result | Proceed to |
| DTC does not reoccur | A |
| DTC reoccurs | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here).
Inspect the steering pad switch (Click here).
Inspect the front No. 1 speaker .
Inspect the front No. 2 speaker .
Inspect the front No. 3 speaker .
Inspect the front No. 4 speaker .
Inspect the rear No. 1 speaker .
Inspect the rear No. 2 speaker .
Inspect the box speaker .
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
|
| ||||
|---|---|---|---|---|---|