Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

NAVIGATION SYSTEM (for CrewMax) > DISPLAY CHECK MODE

for Preparation Click here


HINT:
  1. This mode checks the color display on the navigation receiver.
  2. Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be exactly the same as on the actual vehicle.


ENTER DIAGNOSTIC MODE (Click here)

DISPLAY CHECK


    E120055E02
  1. Select "Display Check" from the "Diagnosis MENU" screen.


COLOR BAR CHECK


    E133028E16
  1. Select "Color Bar Check" from the "Display Check" screen.



  2. E138050
  3. Select a color bar from the "Color Bar Check Mode" screen.

  4. Check the display color.

    HINT:
    1. The entire screen turns to the color or stripe selected.
    2. Touch the display to return to the "Color Bar Check" screen.


TOUCH SWITCH CHECK


    E133028E17
  1. Select "Touch Switch Check" from the "Display Check" screen.



  2. E120103
  3. Touch the display anywhere in the open area to perform the check when the "Touch Switch Check" screen is displayed.

    HINT:
    A "+" mark is displayed on the display is touched.


PANEL SWITCH CHECK


    E133028E18
  1. Select "Panel Switch Check" from the "Display Check" screen.



  2. I100041E07
  3. Operate each switch and check that the switch name and condition are correctly displayed.

    Display
    Contents
    Push switch name/*1
    1. Name of the pressed switch is displayed.
    2. If more than one switch is pressed, "MULTIPLE" is displayed.
    Rotary switch name/*2
    Name of rotary switch is displayed.
    Rotary switch direction/*3
    Direction of rotary switch is displayed.


VEHICLE SIGNAL CHECK


    E133028E19
  1. Select "Vehicle Signal Check" from the "Display Check" screen.



  2. E146767
  3. When the "Vehicle Signal Check Mode" screen is displayed, check all the vehicle signal conditions.

    HINT:
    1. Only conditions having inputs are displayed.
    2. This screen is updated once per second when input signals to the vehicle are changed.
    3. For details of this function, refer to DIAGNOSIS DISPLAY DETAILED DESCRIPTION (Click here).