NAVIGATION SYSTEM (for Double Cab) > Reverse Signal Circuit |

| 1.CHECK NAVIGATION RECEIVER |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K6-5 (REV) - Body ground | Ignition switch ACC, shift lever in R position | 11 to 14 V |
| Ignition switch ACC, shift lever in P position | Below 1 V |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (PARK / NEUTRAL POSITION SWITCH - NAVIGATION RECEIVER AND BATTERY) |
![]() |
Disconnect the K6 receiver connector.
Disconnect the D35 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D35-1 (RL) - K6-5 (REV) | Always | Below 1 Ω |
| D35-1 (RL) - Body ground | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D35-2 (RB) - Body ground | Ignition switch OFF | Below 1 V |
| Ignition switch ACC | 11 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT PARK / NEUTRAL POSITION SWITCH |
![]() |
Disconnect the D35 switch connector
Refer to Automatic Transmission (for A750E) (Click here)
Refer to Automatic Transmission (for A750F) (Click here)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Shift Lever Position | Specified Condition |
| 2 (RB) - 1 (RL) | Ignition switch ACC, shift lever in R position | Below 1 Ω |
| Ignition switch ACC, shift lever in P position | 10 kΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (for A750E) | B |
| NG (for A750F) | C |
|
| ||||
|
| ||||
| A | ||
| ||