DTC P0500 Vehicle Speed Sensor "A" |

| DTC Code | DTC Detection Condition | Trouble Area |
| P0500 | While vehicle being driven, no vehicle speed sensor signal transmitted to ECM (2 trip detection logic) |
|
| Related DTCs | P0500: Vehicle speed sensor "A" pulse input error |
| Required Sensors/Components (Main) | Vehicle Speed Sensor (VSS), Combination meter and Skid control ECU |
| Required Sensors/Components (Related) | Park / Neutral Position (PNP) switch, Engine Coolant Temperature (ECT) sensor, Crankshaft Position (CKP) sensor, Throttle Position (TP) sensor and Mass Air Flow (MAF) meter |
| Frequency of Operation | Continuous |
| Duration | 5 seconds |
| MIL Operation | 2 trip detection logic |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Time after ignition switch OFF to ON | 3 seconds or more |
| Vehicle speed at output speed sensor | 5.59 mph (9 km/h) or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Vehicle speed sensor signal | No pulse input |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check whether the operation of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (VEHICLE SPEED) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Vehicle Speed.
Drive the vehicle.
Read the value displayed on the Techstream.
|
| ||||
| OK | ||
| ||
| 3.CHECK COMBINATION METER ASSEMBLY (+S VOLTAGE) |
![]() |
Disconnect the J28 combination meter connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J28-35 (+S) - Body ground | Ignition switch ON | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 4.CHECK COMBINATION METER ASSEMBLY (SPD SIGNAL WAVEFORM) |
![]() |
Move the shift lever to the neutral position.
Jack up the vehicle.
Check the voltage between the terminal of the combination meter and the body ground while the wheel is turned slowly.
| Tester Connection | Switch Condition | Specified Condition |
| J28-35 (+S) - Body ground | Ignition switch ON | Voltage generated intermittently |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
![]() |
Disconnect the J28 combination meter connector.
Disconnect the A24 ECM connector.
Measure the resistance according the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J28-35 (+S) - A24-13 (SPD) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| J28-35 (+S) or A24-13 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||