Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for Double Cab)

NAVIGATION SYSTEM (for Double Cab) > Microphone Circuit between Microphone and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the microphone to the navigation receiver.

WIRING DIAGRAM


E137987E10


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER


    E138081E01
  1. Check that waveform of the microphone using an oscilloscope.

    OK:
    Waveform that matches sound spoken into microphone is output.
    Item
    Content
    Tester Connection
    K7-19 (MIC+) - K7-20 (MIC-)
    Tool Setting
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch ACC and steering pad switch's "Voice" switch is pressed

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - ROOF CONSOLE BOX)


    E138082E02
  1. Disconnect the K7 receiver connector.

  1. Disconnect the W7 console connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K7-17 (MACC) - W7-10 (ACC)
    Always
    Below 1 Ω
    K7-19 (MIC+) - W7-9 (MI1+)
    K7-20 (MIC-) - W7-8 (MIC-)
    K7-17 (MACC) - Body ground
    Always
    10 kΩ or higher
    K7-19 (MIC+) - Body ground
    K7-20 (MIC-) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK NAVIGATION RECEIVER (MACC VOLTAGE)


    E138081E02
  1. Reconnect the K7 receiver connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K7-17 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A


4.REPLACE MICROPHONE AMPLIFIER WITH ANOTHER AND CHECK
  1. Replace the microphone amplifier with a normal one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY
OK

END (MICROPHONE AMPLIFIER IS FAULTY)