NAVIGATION SYSTEM (for CrewMax) > Microphone Circuit between Microphone and Navigation Receiver Assembly |

| 1.CHECK NAVIGATION RECEIVER |
![]() |
Check that waveform of the microphone using an oscilloscope.
| Item | Content |
| Tester Connection | K7-19 (MIC+) - K7-20 (MIC-) |
| Tool Setting | 0.2 V/DIV., 0.2 μsec./DIV. |
| Condition | Ignition switch ACC and steering pad switch's "Voice" switch is pressed |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - ROOF CONSOLE BOX) |
![]() |
Disconnect the K7 receiver connector.
Disconnect the W7 console connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K7-17 (MACC) - W7-10 (ACC) | Always | Below 1 Ω |
| K7-19 (MIC+) - W7-9 (MI1+) | ||
| K7-20 (MIC-) - W7-8 (MIC-) | ||
| K7-17 (MACC) - Body ground | Always | 10 kΩ or higher |
| K7-19 (MIC+) - Body ground | ||
| K7-20 (MIC-) - Body ground |
|
| ||||
| OK | |
| 3.CHECK NAVIGATION RECEIVER (MACC VOLTAGE) |
![]() |
Reconnect the K7 receiver connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K7-17 (MACC) - Body ground | Ignition switch ACC | 4 to 6 V |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 4.REPLACE MICROPHONE AMPLIFIER WITH ANOTHER AND CHECK |
Replace the microphone amplifier with a normal one (Click here).
Check if the same problem occurs again.
|
| ||||
| OK | ||
| ||