Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT
  1. for 1GR-FE:
    Drain engine coolant .

  1. for 2UZ-FE:
    Drain engine coolant .

  1. for 3UR-FE, 3UR-FBE:
    Drain engine coolant .



2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned LOCK, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch LOCK, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE NO. 2 COOLER COVER


E146043
  1. Remove the 2 nuts.

  1. Detach the 2 claws and remove the cover.



5. REMOVE TUBE SUB-ASSEMBLY


    E142173E01
  1. Remove the bolt.

  1. Detach the plate as shown in the illustration.



    I043960E02
  1. Disconnect the suction tube and liquid tube.

    NOTICE:
    1. Do not use a screwdriver or similar tool to disconnect the tube.
    2. Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  1. Remove the 2 O-rings from the suction tube and liquid tube.



6. DISCONNECT INLET HEATER WATER HOSE AND OUTLET HEATER WATER HOSE


    E148621E04
  1. Using pliers, grip the claws of the clip and slide the clip.

  1. Disconnect the 2 heater water hoses.



7. REMOVE FRONT WIPER MOTOR AND BRACKET
  1. Remove the front wiper motor and bracket (Click here).



8. REMOVE STEERING COLUMN ASSEMBLY
  1. Remove the steering column (Click here).



9. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. for Column Shift Type:
    Remove the instrument panel (Click here).

  1. for Floor Shift Type:
    Remove the instrument panel (Click here).



10. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY
  1. Disconnect the clamps, connectors and wire harness.



  1. Remove the 8 bolts, 2 screws and 4 nuts.


    E146061



  1. Remove the instrument panel reinforcement.

    1. Driver side:
      Remove the 3 bolts and 3 caps.

    2. Passenger side:
      Using a T40 "TORX" socket, remove the 2 "TORX" bolts.

      HINT:
      When removing the bolts, the collars may come off with the bolts.



    3. Passenger side:
      Using a 12 mm hexagon wrench, remove the 2 collars.


      E146041E02



11. REMOVE AIR CONDITIONING UNIT


  1. Remove the nut and air conditioning unit.


    E146042