Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab)

AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab) > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the audio system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the audio system will not function normally as the communication is discontinued.

INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER
E145928E01
  1. Disconnect the K4 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K4-5 (ATX+) - K4-15 (ATX-)
    Always
    60 to 80 Ω

    Result: 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE RADIO RECEIVER (Click here)

C
REPLACE RADIO RECEIVER (Click here)
A


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE)

HINT:
For details of the connectors, refer to the "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.



    2. Check for an open or short in all AVC-LAN circuits.

      OK:
      There is no open or short circuit.


      E138055E03



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)