Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

DTC    5C-40    Camera Picture Error

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
5C-40
Synchronous signal from camera cannot be transmitted.
  1. Harness and connector
  2. Television camera
  3. Navigation receiver

WIRING DIAGRAM


E126423E16


INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs (Click here).

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION CAMERA)
E146365E01
  1. Disconnect the K7 receiver connector.

  1. Disconnect the X1 camera connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    X1-3 (CB+) - K7-24 (CA+)
    Always
    Below 1 Ω
    X1-4 (CGND) - K7-21 (CGND)
    X1-1 (CV+) - K7-22 (V+)
    X1-2 (CV-) - K7-23 (V-)
    X1-3 (CB+) - Body ground
    Always
    10 kΩ or higher
    X1-4 (CGND) - Body ground
    X1-1 (CV+) - Body ground
    X1-2 (CV-) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK NAVIGATION RECEIVER (CA+ VOLTAGE)


    I102033E06
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K7-24 (CA+) - K7-21 (CGND)
    Ignition switch ON, shift lever in R position
    5.5 to 7.05 V

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A

REPLACE TELEVISION CAMERA ASSEMBLY (Click here)