Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

DTC    B1242    Wireless Door Lock Tuner Circuit Malfunction

for Preparation Click here


DESCRIPTION

The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is output when the applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.

DTC No.
DTC Detection Condition
Trouble Area
B1242
In diagnostic mode, applicable RDA signal cannot be received within 1 second of PRG signal being output from main body ECU
  1. Harness or connector
  2. Door control receiver
  3. Main body ECU

WIRING DIAGRAM


E146625E01


INSPECTION PROCEDURE

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTC (Click here).

    OK:
    DTC B1242 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DOOR CONTROL RECEIVER)
E145679E01
  1. Disconnect the J3 ECU connector.

  1. Disconnect the Q7 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J3-12 (RDA) - Q7-2 (RDA)
    Always
    Below 1 Ω
    J3-10 (PRG) - Q7-3 (PRG)
    J3-12 (RDA) or Q7-2 (RDA) - Body ground
    Always
    10 kΩ or higher
    J3-10 (PRG) or Q7-3 (PRG) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)
B129963E02
  1. Disconnect the Q7 receiver connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q7-1 (GND) - Body ground
    Always
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Q7-5 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE DOOR CONTROL RECEIVER
  1. Temporarily replace the door control receiver with a new or normally functioning one.

    1. For Regular Cab, refer to the following procedures (Click here).

    2. For Double Cab, refer to the following procedures (Click here).

    3. For CrewMax, refer to the following procedures (Click here).

  1. Perform the REGISTRATION procedures (Click here).


NEXT


6.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


7.CHECK FOR DTC
  1. Check for DTC (Click here).

    OK:
    DTC B1242 is not output.



NG
REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)
OK

END (DOOR CONTROL RECEIVER IS DEFECTIVE)