Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK SENSOR


    A078438E11
  1. Install the 2 sensors with the 2 bolts as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the 2 sensor connectors.



2. INSTALL NO. 1 WATER OUTLET PIPE


    A191545
  1. Install the water outlet pipe with the bolt and 2 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Install the 4 wire harness clamps.



3. INSTALL CYLINDER HEAD SUB-ASSEMBLY RH (for Bank 1)
  1. Install the cylinder head RH (Click here).



4. INSTALL ENGINE ASSEMBLY
  1. Install the engine (Click here).