Home › ENGINE ยท 2UZ-FE › STARTING › STARTER (for 2.0 kW Type)

STARTER (for 2.0 kW Type) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY


    A164439
  1. Connect the starter wire with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Connect the starter connector.

  1. Connect the starter to the cylinder block.

  1. Connect the ground wire with the bolt.

    Torque:
    17 N*m{ 173 kgf*cm , 13 ft.*lbf }

  1. Install the engine wire protector to the starter with the bolt.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



    A164438
  1. Install the starter with the 2 bolts.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



2. INSTALL AIR PUMP ASSEMBLY


    A158347E01
  1. Install the air pump with the 2 bolts and 2 nuts.

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }

  1. Connect the air pump connector.



3. INSTALL NO. 4 AIR INJECTION SYSTEM HOSE


4. INSTALL WATER BY-PASS PIPE SUB-ASSEMBLY
  1. Install a new O-ring to the water by-pass pipe.

  1. Apply soapy water to the O-ring.



    A162643
  1. Push in the water by-pass pipe.

  1. Connect the water by-pass pipe with the bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Connect the connector clamp.



5. INSTALL INTAKE MANIFOLD ASSEMBLY
  1. Install the intake manifold (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).