Home › ENGINE ยท 2UZ-FE › STARTING › STARTER (for 1.4 kW Type)

STARTER (for 1.4 kW Type) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE INTAKE MANIFOLD ASSEMBLY
  1. Remove the intake manifold (Click here).



3. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY


    A159345
  1. Disconnect the connector clamp.

  1. Remove the bolt.

  1. Pull out the water by-pass pipe.

  1. Remove the O-ring from the water by-pass pipe.



4. REMOVE NO. 4 AIR INJECTION SYSTEM HOSE


5. REMOVE AIR PUMP ASSEMBLY


A153506E01
  1. Disconnect the air pump connector.

  1. Remove the 2 bolts, 2 nuts and air pump.



6. REMOVE STARTER ASSEMBLY


    A159480
  1. Remove the 2 bolts holding the starter to the cylinder block.

  1. Disconnect the starter from the cylinder block.



    A159481
  1. Remove the bolt and disconnect the engine wire protector from the starter.

  1. Remove the bolt and ground wire.

  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.

  1. Remove the starter.