Home › ENGINE ยท 3UR-FBE › STARTING › IGNITION SWITCH

IGNITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION SWITCH ASSEMBLY


C155157
  1. Attach the 2 claws to install the ignition switch to the steering lock.



2. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt)
  1. Temporarily install the upper steering column with switch bracket and the steering lock bracket with 2 new tapered-head bolts.



    C155159
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



3. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)
  1. Temporarily install the upper steering column with switch bracket and steering lock bracket with 2 new tapered-head bolts.



    C159755
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



4. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)
  1. Temporarily install the steering column upper with switch bracket and the steering lock bracket with 2 new tapered-head bolts.



    C159756
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



5. INSTALL STEERING COLUMN ASSEMBLY
  1. for Manual Tilt:
    Install the steering column assembly (Click here).

  1. for Manual Tilt and Telescopic:
    Install the steering column assembly (Click here).

  1. for Power Tilt and Power Telescopic:
    Install the steering column assembly (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).