Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE INTAKE MANIFOLD ASSEMBLY
  1. Remove the intake manifold (Click here).



3. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY


    A159345
  1. Disconnect the connector clamp.

  1. Remove the bolt.

  1. Pull out the water by-pass pipe.

  1. Remove the O-ring from the water by-pass pipe.



4. REMOVE NO. 4 AIR INJECTION SYSTEM HOSE


5. REMOVE KNOCK SENSOR


    A159538
  1. Disconnect the 2 sensor connectors.

  1. Remove the 2 nuts and 2 sensors.