Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0575    Cruise Control Input Circuit

for Preparation Click here


DESCRIPTION

This DTC indicates the internal abnormalities of the ECM.

DTC Code
DTC Detection Condition
Trouble Area
P0575
When either of following conditions is met:
  1. Cruise control input signal abnormal
  2. Stop light switch input signal abnormal
ECM

HINT:
If DTC P0575 is detected while the cruise control is in operation, the skid control ECU clears the stored vehicle speed in the ECM and cancels the cruise control operation. At the same time, the CRUISE main indicator light blinks to inform the driver of the malfunction. When this trouble code is detected, fail-safe remains on until the ignition switch is turned OFF.


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Recheck for DTC (Click here).

    OK:
    DTC P0575 is not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1GR-FE)
    B
    NG (for 2UZ-FE)
    C
    NG (for 3UR-FE)
    D
    NG (for 3UR-FBE)
    E



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)

E
REPLACE ECM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)