POWER DOOR LOCK CONTROL SYSTEM > Rear Door Lock Motor Circuit |

| 1.INSPECT REAR DOOR LOCK MOTOR ASSEMBLY |
![]() ![]() |
Remove the rear door lock motor (Click here).
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 (L) Battery negative (-) → Terminal 1 (UL) | Lock |
| Battery positive (+) → Terminal 1 (UL) Battery negative (-) → Terminal 4 (L) | Unlock |
Remove the rear door lock motor (Click here).
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 (L) Battery negative (-) → Terminal 1 (UL) | Lock |
| Battery positive (+) → Terminal 1 (UL) Battery negative (-) → Terminal 4 (L) | Unlock |
| Result | Proceed to |
| OK (Rear door lock motor LH) | A |
| OK (Rear door lock motor RH) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (REAR DOOR LOCK MOTOR LH - MAIN BODY ECU) |
![]() |
Disconnect the O10 door lock connector.
Disconnect the DC ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O10-4 (L) - DC-24 (ACT+) | Always | Below 1 Ω |
| O10-1 (UL) - DC-23 (ACT-) | ||
| DC-24 (ACT+) - Body ground | Always | 10 kΩ or higher |
| DC-23 (ACT-) - Body ground |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (REAR DOOR LOCK MOTOR RH - MAIN BODY ECU) |

Disconnect the O4 door lock connector.
Disconnect the DD ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O4-4 (L) - DD-3 (ACT+) | Always | Below 1 Ω |
| O4-1 (UL) - DD-2 (ACT-) | ||
| DD-3 (ACT+) - Body ground | Always | 10 kΩ or higher |
| DD-2 (ACT-) - Body ground |
|
| ||||
| OK | ||
| ||