Home › ENGINE ยท 1GR-FE › EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE AIR SWITCHING VALVE ASSEMBLY
  1. Remove the air switching valve (Click here).



3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for Regular Cab Standard Deck)
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 3 nuts and front No. 2 exhaust pipe.



4. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (except Regular Cab Standard Deck)
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 3 nuts.

  1. Disconnect the front No. 2 exhaust pipe from the exhaust pipe support.



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Detach the 2 heated oxygen sensor wire clamps.

  1. Remove the 3 nuts and front exhaust pipe.



6. REMOVE EXHAUST MANIFOLD RH


    A151777E01
  1. Remove the 6 nuts, exhaust manifold and gasket.



7. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A151779E01
  1. Remove the 3 bolts and heat insulator.



8. REMOVE EXHAUST MANIFOLD LH
  1. Remove the 6 nuts, exhaust manifold and gasket.