Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

HINT:
  1. Refer to the procedures up to "REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Column Shift Type) (Click here).
  2. Refer to the procedures up to "REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Floor Shift Type) (Click here).



3. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY


    B160596
  1. Remove the 3 screws and register.



4. REMOVE NO. 1 HEATER TO REGISTER DUCT WITH NO. 2 HEATER TO REGISTER DUCT


  1. Remove the 5 screws and duct.


    B161141



5. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT


    B160598
  1. Remove the 2 screws.

  1. Detach the claw and remove the duct.



6. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    B166453
  1. Disconnect the 2 connectors and remove the instrument panel wire from the front passenger airbag.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



    B166454
  1. Remove the 2 screws.



    B166455E01
  1. Detach the 5 hooks (A).

  1. Detach the 5 hooks (B) and remove the front passenger airbag from the instrument panel.