Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY (for CrewMax)

CURTAIN SHIELD AIRBAG ASSEMBLY (for CrewMax) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for CrewMax) (Click here).



3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



  1. Remove the 10 bolts and curtain shield airbag.


    B169088