SEAT POSITION SENSOR > INSTALLATION |
| 1. INSTALL SEAT POSITION SENSOR |
![]() |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
![]() |
Using a feeler gauge 1.0 mm (0.0393 in.), install the seat position sensor.
Using a T30 "TORX" socket wrench, install the seat position sensor with the screw.
Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 to 1.4 mm (0.0236 to 0.0551 in.).
Check that there is no looseness in the installation parts of the seat position sensor.
Connect the connector.
Install the seat slide position sensor protector to the seat position sensor.
| 2. INSTALL FRONT SEAT ASSEMBLY LH |
Install the front seat (Click here).
| 3. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).