Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION ANTENNA

NAVIGATION ANTENNA > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. for Column Shift Type:
    Remove the instrument panel (Click here).

  1. for Floor Shift Type:
    Remove the instrument panel (Click here).



3. REMOVE NO. 1 HEATER TO REGISTER DUCT WITH NO. 2 HEATER TO REGISTER DUCT


  1. Remove the 5 screws and duct.


    B161141



4. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B160598
  1. Remove the 2 screws.

  1. Detach the claw and remove the duct.



5. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    B160599
  1. Remove the 2 screws.

  1. Detach the claw and remove the duct.



6. REMOVE DEFROSTER NOZZLE ASSEMBLY


    B160597
  1. Remove the 3 screws and nozzle.



7. REMOVE NAVIGATION ANTENNA ASSEMBLY
  1. Detach the clamp.



  1. Remove the 2 screws and antenna.


    B164817