Home › ENGINE ยท 3UR-FBE › EMISSION CONTROL › AIR SWITCHING VALVE

AIR SWITCHING VALVE > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY
  1. Remove the exhaust manifold (Click here).



2. REMOVE INTAKE MANIFOLD
  1. Remove the intake manifold (Click here).



3. REMOVE FAN SHROUD
  1. Remove the fan shroud (Click here).



4. DISCONNECT NO. 1 WATER BY-PASS HOSE


    A158577E02
  1. Disconnect the No. 1 water by-pass hose from the water by-pass joint and water inlet housing.



5. DISCONNECT NO. 2 WATER BY-PASS HOSE
  1. Disconnect the No. 2 water by-pass hose from the water by-pass joint.



6. DISCONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Trailer Towing System)


    A158578
  1. Remove the 3 bolts and disconnect the No. 2 water by-pass pipe.



7. REMOVE NO. 2 ENGINE COVER


A158576


8. DISCONNECT FUEL TUBE CLAMP


    A158580
  1. Disconnect the fuel tube clamp from the bracket.



9. REMOVE NO. 1 ENGINE COVER


A158581


10. REMOVE FRONT WATER BY-PASS JOINT
  1. Disconnect the engine coolant temperature sensor connector.



    A158579
  1. Remove the 4 nuts, front water by-pass joint and 2 gaskets.



11. REMOVE AIR TUBE


    A158575E02
  1. Disconnect the No. 2 and No. 3 hoses.

  1. Disconnect the air pump connector.

  1. Disconnect the air pump connector clamp's holder.

  1. Using a clip remover, detach the wire harness claw.



    A158582
  1. Remove the 2 bolts and air tube.

  1. Disconnect the 2 No. 1 air hoses from the air tube.



12. REMOVE AIR SWITCHING VALVE ASSEMBLY


    A158583
  1. Disconnect the knock sensor connector.

  1. Remove the bolt and bracket.

  1. Disconnect the 2 air switching valve connectors.



    A158586
  1. Remove the 3 bolts and air switching valve.



13. REMOVE NO. 2 AIR TUBE


    A158584
  1. Remove the 2 bolts, No. 2 air tube and gasket.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



14. REMOVE NO. 3 AIR TUBE


    A158585
  1. Remove the 2 bolts, No. 3 air tube and gasket.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.