Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Display Signal Circuit between Video Terminal and Television Display

for Preparation Click here


DESCRIPTION

This is the display signal from the video terminal to the television display.

WIRING DIAGRAM


E145848E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - VIDEO TERMINAL)


    E145847E02
  1. Disconnect the W2 display connector.

  1. Disconnect the T4 terminal connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    W2-24 (ADPG) - T4-8 (ADPG)
    Always
    Below 1 Ω
    W2-6 (VV+) - T4-5 (VV+)
    W2-22 (VV-) - T4-6 (VV-)
    W2-25 (SGN2) - T4-7 (SG)
    W2-24 (ADPG) - Body ground
    Always
    10 kΩ or higher
    W2-6 (VV+) - Body ground
    W2-22 (VV-) - Body ground
    W2-25 (SGN2) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK VIDEO TERMINAL


    E150834E01
  1. Reconnect the T4 terminal connector.

  1. Check that waveform of the display using an oscilloscope.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Terminal No. (Symbols)
    T4-5 (VV+) - Body ground
    Tool Setting
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    External device is playing, VTR is displayed
    Result 
    Result
    Proceed to
    OK
    A
    NG (for Separate Seat Type)
    B
    NG (for Bench Seat Type)
    C



B
REPLACE VIDEO TERMINAL (Click here)

C
REPLACE VIDEO TERMINAL (Click here)
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)