DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Conditions (a) and (b) are met for 2.0 seconds (1 trip detection logic): (a) Throttle actuator duty ratio is 80% or more. (b) Throttle actuator current is below 0.5 A. |
|
| P2103 | Either condition is met (1 trip detection logic):
|
|
| Related DTCs | P2102: Throttle actuator current (low current) P2103: Throttle actuator current (high current) |
| Required Sensors/Components (Main) | Throttle actuator (throttle body with motor assembly) |
| Required Sensors/Components (Related) | None |
| Frequency of Operation | Continuous |
| Duration | 2 seconds: P2102 25 times: P2103 (Case 1) 0.6 seconds: P2103 (Case 2) |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not stored | None |
| Throttle actuator | ON |
| Duty cycle to open throttle actuator | 80% or more |
| Throttle actuator power supply | 8 V or higher |
| Motor current change during latest 0.016 sec | Less than 0.2 A |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Throttle actuator | ON |
| Either of the following conditions 1 or 2 met: | - |
| 1. Throttle actuator power supply voltage | 8 V or higher |
| 2. Throttle actuator power | ON |
| Throttle actuator current | Below 0.5 A |
| Hybrid IC diagnosis signal | Fail |
| Hybrid IC current limiter monitor input | Fail |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
Inspect the throttle body with motor assembly .
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE BODY WITH MOTOR ASSEMBLY - ECM) |
Disconnect the throttle body with motor assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D9-2 (M+) - D74-19 (M+) | Always | Below 1 Ω |
| D9-1 (M-) - D74-18 (M-) | Always | Below 1 Ω |
| D9-2 (M+) or D74-19 (M+) - Body ground | Always | 10 kΩ or higher |
| D9-1 (M-) or D74-18 (M-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY |
Check for foreign objects between the throttle valve and housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE VALVE |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||