FUEL INJECTOR > INSTALLATION |
| 1. INSTALL FUEL INJECTOR ASSEMBLY |
![]() |
Install a new insulator to each fuel injector.
| *1 | New Insulator |
| *2 | New O-Ring |
Apply a light coat of spindle oil or gasoline to new O-rings and install one to each fuel injector.
Install the 6 injectors.
![]() |
While turning each fuel injector left and right, install it to the fuel delivery pipe.
| *1 | Connector |
![]() | Outward |
![]() | Turn |
![]() | Push |
Position the fuel injectors with the connectors facing outward.
| 2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY |
Place the fuel delivery pipe together with the 6 fuel injectors on the intake manifold.
Temporarily install the 4 bolts, which are used to hold the fuel delivery pipe in place, to the intake manifold.
![]() |
Check that the fuel injectors rotate smoothly.
![]() | Turn |
Position the fuel injectors with the connectors facing outward.
Tighten the 4 bolts.
Connect the 6 fuel injector connectors.
| 3. CONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY |
Connect the No. 2 fuel pipe sub-assembly (Click here).
| 4. CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY |
Connect the No. 1 fuel pipe sub-assembly (Click here).
| 5. CONNECT WIRE HARNESS |
Attach the 3 wire harness clamps.
Connect the engine coolant temperature sensor connector.
| 6. INSTALL INTAKE AIR SURGE TANK |
| 7. INSPECT FOR FUEL LEAK |
Make sure that there are no fuel leaks after performing maintenance on the fuel system.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no leaks from the fuel system.
If there are fuel leaks, repair or replace parts as necessary.
Turn the ignition switch off.
Disconnect the Techstream from the DLC3.