FUEL PRESSURE PULSATION DAMPER > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. PRECAUTION |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE INTAKE AIR SURGE TANK |
| 5. DISCONNECT WIRE HARNESS |
![]() |
Disconnect the engine coolant temperature sensor connector.
Detach the 3 wire harness clamps and disconnect the wire harness.
| 6. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY |
![]() |
Remove the fuel pressure regulator holder.
Pull the fuel pressure pulsation damper out of the fuel delivery pipe.
Remove the O-ring from the fuel pressure pulsation damper.