Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Read the "ID Tire Inflation Pressure" values.
Adjust all tire pressures to the standard values (Click here).
Check the Data List (Click here).
- HINT:
- It may take up about 5 to 6 minutes to display the updated tire pressure data.
- If the problem is that the tire pressure decreases, wait until all of the tire pressure data is received by the ECU. If the data is received, the tire pressure warning light will turn off.
Result
Result
| Proceed to
|
Tire pressure warning light remains on.
| A
|
Tire pressure warning light goes off.
| B
|