FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FOR FUEL PUMP OPERATION AND FUEL LEAKS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check fuel pump operation.
Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
If there is no sound, check the integration relay, fuel pump, ECM and wiring connector.
Inspect for fuel leaks .
Check that there are no fuel leaks after performing maintenance anywhere on the system.
If there are fuel leaks, repair or replace parts as necessary.
| 2. CHECK FUEL PRESSURE |
Check the battery voltage (Click here).
Discharge the fuel system pressure (Click here).
Disconnect the cable from the negative (-) battery terminal.
![]() |
Remove the fuel pipe clamp from the fuel tube connector.
Disconnect the No. 1 fuel pipe sub-assembly (Click here).
![]() |
Install SST (pressure gauge) as shown in the illustration.
| *1 | SST (Hose) |
| *2 | SST (Hose Band) |
| *3 | SST (T-joint) |
| *4 | SST (Pressure Gauge) |
| *5 | SST (Hose Joint) |
| *6 | No. 1 Fuel Tube Sub-assembly |
| *7 | SST (Fuel Tube Connector) |
Wipe off any gasoline.
Reconnect the cable to the negative (-) battery terminal.
Operate the fuel pump.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Measure the fuel pressure.
Start the engine.
Measure the fuel pressure.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.
Disconnect the cable from the negative (-) battery terminal and carefully remove SST and the fuel tube connector to prevent gasoline from spraying.
Connect the No. 1 fuel pipe sub-assembly (Click here).
Check for fuel leaks.
Check that there are no fuel leaks after performing maintenance anywhere on the system.
If there are fuel leaks, repair or replace parts as necessary.