Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the navigation system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage with the ignition switch off.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT


    3.BASIC INSPECTION
    1. Turn the ignition switch to ACC.

    2. Check whether or not the display appears on the navigation receiver assembly.
      Result 
      Result
      Proceed to
      Display appears
      A
      Display does not appear
      B



    B.
    Go to step 6
    A


    4.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs.

    3. Recheck for DTCs by simulating the operation indicated by the DTCs.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    5.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).

    2. Inspect the front No. 1 speaker assembly (for Regular Cab) (Click here).

    3. Inspect the front No. 1 speaker assembly (for Double Cab) (Click here).

    4. Inspect the front No. 1 speaker assembly (for CrewMax) (Click here).

    5. Inspect the front No. 2 speaker assembly (for Regular Cab) (Click here).

    6. Inspect the front No. 2 speaker assembly (for Double Cab) (Click here).

    7. Inspect the front No. 2 speaker assembly (for CrewMax) (Click here).

    8. Inspect the rear No. 1 speaker assembly (for Double Cab) (Click here).

    9. Inspect the rear No. 1 speaker assembly (for CrewMax) (Click here).


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      HINT:
      After clearing the DTCs, recheck for DTCs (Click here).


    NEXT


    8.RECHECK FOR DIAGNOSTIC TROUBLE CODE

      NEXT


      9.PERFORM CONFIRMATION TEST

        NEXT

        END