Home › ENGINE ยท 1GR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


2. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE INTAKE AIR SURGE TANK
(Click here)


5. DISCONNECT WIRE HARNESS


    A239472
  1. Disconnect the engine coolant temperature sensor connector.

  1. Detach the 3 wire harness clamps and disconnect the wire harness.



6. DISCONNECT WATER BY-PASS PIPE


    A239473
  1. Remove the 2 bolts and disconnect the water by-pass pipe.



7. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY


    A239743
  1. Disconnect the No. 2 fuel pipe sub-assembly (Click here).



8. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
  1. Disconnect the vacuum hose.



    A239747
  1. Remove the 2 bolts and fuel pressure regulator.

  1. Remove the O-ring from the fuel pressure regulator.