Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



2. DRAIN ENGINE COOLANT
  1. for 1GR-FE:
    Drain engine coolant .

  1. for 1UR-FE:
    Drain engine coolant .

  1. for 3UR-FE:
    Drain engine coolant .

  1. for 3UR-FBE:
    Drain engine coolant .



3. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE NO. 2 COOLER COVER


E146043
  1. Remove the 2 nuts.

  1. Detach the 2 claws and remove the cover.



6. REMOVE SUCTION PIPE SUB-ASSEMBLY AND LIQUID TUBE


    E142173E01
  1. Remove the bolt.

  1. Detach the plate as shown in the illustration.



    I043960E02
  1. Disconnect the suction pipe sub-assembly and liquid tube.

    NOTICE:
    1. Do not use a screwdriver or similar tool to disconnect the tube.
    2. Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  1. Remove the 2 O-rings from the suction pipe sub-assembly and liquid tube.



7. DISCONNECT INLET HEATER WATER HOSE AND OUTLET HEATER WATER HOSE


E186293E01
  1. Using pliers, grip the claws of the clip and slide the clip.

  1. Disconnect the 2 heater water hoses.



8. REMOVE FRONT WIPER MOTOR AND BRACKET
  1. Remove the front wiper motor and bracket (Click here).



9. REMOVE STEERING COLUMN ASSEMBLY
  1. Remove the steering column (Click here).



10. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. for Column Shift Type:
    Remove the instrument panel .

  1. for Floor Shift Type:
    Remove the instrument panel .



11. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY
  1. Disconnect the clamps, connectors and wire harness.



  1. Remove the 8 bolts, 2 screws and 4 nuts.


    E146061



  1. Remove the instrument panel reinforcement.

    1. for Driver Side:
      Remove the 3 bolts and 3 caps.

    2. for Passenger Side:
      Using a T40 "TORX" socket, remove the 2 "TORX" bolts.

      HINT:
      When removing the bolts, the collars may come off with the bolts.



    3. for Passenger Side:
      Using a 12 mm hexagon wrench, remove the 2 collars.


      E146041E02



12. REMOVE AIR CONDITIONING UNIT


  1. Remove the nut and air conditioning unit.


    E146042