DTC B15C2 Speed Signal Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B15C2 | A difference between the GPS speed and SPD pulse is detected. |
|

| 1.CHECK VEHICLE SENSOR |
![]() |
Enter the "Function Check/Setting" mode and select "GPS & Vehicle Sensors" (Click here).
While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are equal or almost equal.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMBINATION METER) |
![]() |
Disconnect the K6 navigation receiver assembly connector.
Disconnect the J28 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K6-3 (SPD) - J28-35 (+S) | Always | Below 1 Ω |
| K6-3 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER ASSEMBLY (SPEED SIGNAL) |
![]() |
Remove the combination meter assembly with the connector(s) still connected.
Connect an oscilloscope to terminal J28-35 (+S) and body ground.
Turn the ignition switch to ON.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
| Terminal No. (Symbol) | J28-35 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Vehicle being driven at approx, 20 km/h (12 mph) |
|
| ||||
| OK | ||
| ||