AUDIO AND VISUAL SYSTEM > Radio Receiver Communication Error |

| 1.IDENTIFY COMPONENT SHOWN BY SUB-CODE |
Enter the diagnostic mode.

Press the preset switch "channel 3" to change to "Detailed Information Mode".
Identify the component shown by the sub-code.
| NEXT | |
| 2.CHECK COMPONENT SHOWN BY SUB-CODE |
Select the component which has stored this code.
| Component | Proceed to |
| Except "Bluetooth" handsfree module and satellite radio tuner | A |
| "Bluetooth" handsfree module (19D)*2 | B |
| Satellite radio tuner (1F1)*1, *3 | |
| "Bluetooth" handsfree module (19D)*3 | C |
| Satellite radio tuner (1F1)*1, *3 |
|
| ||||
|
| ||||
| A | |
| 3.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE |
Inspect the power source circuit of the component shown by the sub-code.
| Component | Proceed to |
| Stereo component amplifier assembly (440)*1 | Stereo Component Amplifier Power Source Circuit (Click here) |
| Multi-media interface ECU (388)*3 | Multi-media Interface ECU Power Source Circuit (Click here) |
| Television display assembly (1B0)*2 | Television Display Assembly Power Source Circuit (Click here) |
| NEXT | |
| 4.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the K4*1 and K22*2 radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K4-5 (ATX+) - K4-15 (ATX-)*1 | Always | 60 to 80 Ω |
| K22-9 (TXM+) - K22-10 (TXM-)*2 | Always | 60 to 80 Ω |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 5.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE) |
Referring to the wiring diagram below, check the AVC-LAN circuit between the radio receiver assembly and the component shown by the sub-code.
Disconnect all connectors between the radio receiver assembly and the component shown by the sub-code.
Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component shown by the sub-code.
|
| ||||
| OK | |
| 6.REPLACE COMPONENT SHOWN BY SUB-CODE |
Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | ||
| ||