Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Radio Broadcast cannot be Received or Poor Reception

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY
  1. Check the radio automatic station search function.

    1. Check the radio automatic station search function by activating it.

      OK:
      The radio automatic station search function works properly.

      Result 
      Result
      Proceed to
      OK (for Column Shift Type)
      A
      OK (for Floor Shift Type)
      B
      NG
      C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
Go to step 2
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

2.CHECK OPTIONAL COMPONENTS
  1. Check for optional components (sun-shade film, telephone antenna, etc.).

    1. Check if any optional components, that may decrease reception capacity, such as a sunshade film or telephone antenna, are installed.

      OK:
      Optional components are installed.

      NOTICE:
      Do not remove any optional components installed by the customer without his or her consent.



NG
Go to step 3
OK

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE) 

3.CHECK NAVIGATION RECEIVER ASSEMBLY (ANTENNA)


    E050367E01
  1. Preparation for check

    1. Remove the antenna plug from the navigation receiver assembly.

  1. Check for noise

    1. Turn the ignition switch to ACC with the navigation receiver assembly connector connected.

    2. Turn the radio on and change the AM mode.

    3. Place a screwdriver, thin wire, or other metal object on the navigation receiver's antenna jack and check that noise can be heard from the speaker.

      OK:
      Noise occurs.



NG
REPLACE AMPLIFIER ANTENNA ASSEMBLY AND ANTENNA CORD SUB-ASSEMBLY
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)