Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch assembly and information about the GPS antenna, and then adjusts the vehicle position.

WIRING DIAGRAM


E190586E08


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK VEHICLE SIGNAL


    E181227
  1. Enter the "Function Check/Setting" mode and select "Vehicle Signal" (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever operation.

    OK:
    Shift Lever Position
    Display
    R
    ON
    Except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual shift lever operation.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK NAVIGATION RECEIVER ASSEMBLY


    E146425E12
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K6-5 (REV) - Body ground
    Ignition switch ON
    Shift lever in R
    11 to 14 V
    K6-5 (REV) - Body ground
    Ignition switch ON
    Shift lever in any position except R
    Below 1 V



NG
Go to step 3
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARK/NEUTRAL POSITION SWITCH)


    E138080E09
  1. Disconnect the K6 navigation receiver assembly connector.

  1. Disconnect the D35 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K6-5 (REV) - D35-1 (RL)
    Always
    Below 1 Ω
    K6-5 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    E179071E07
  1. Disconnect the D35 park/neutral position switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (RL) - 2 (RB)
    Shift lever in R
    Below 1 Ω
    Shift lever in P
    10 kΩ or higher

    HINT:
    1. Replace the park/neutral position switch assembly (for AB60E) (Click here)
    2. Replace the park/neutral position switch assembly (for AB60F) (Click here)
    3. Replace the park/neutral position switch assembly (for A760E) (Click here)
    4. Replace the park/neutral position switch assembly (for A760F) (Click here)
    5. Replace the park/neutral position switch assembly (for A750E) (Click here)



NG
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR