NAVIGATION SYSTEM (for DVD) > Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier |

| 1.CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K15-1 (MUTE) - Body ground | Ignition switch ACC, Audio system playing → Changing source | Above 3.5 V → Below 1 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the K18 navigation receiver assembly connector.
Disconnect the K15 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K18-7 (MUTE) - K15-1 (MUTE) | Always | Below 1 Ω |
| K18-7 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||