Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Multi-media Interface ECU Communication Error

for Preparation Click here


WIRING DIAGRAM


E189530E07


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


  1. Enter diagnostic mode.


    E146440E06

  1. Press preset switch "channel 2" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. "190 (radio receiver assembly)" is the component shown by the sub-code in the example shown in the illustration.
    2. For details of the DTC display, refer to DTC Check/Clear (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    HINT:
    The satellite radio tuner is built into the radio receiver assembly. If there is a problem between the satellite radio tuner and radio receiver, replace the radio receiver assembly.


    Component Table 
    Component
    Proceed to
    Radio receiver assembly (190)
    Radio Receiver Power Source Circuit (Click here)
    "Bluetooth" handsfree module (19D)
    Satellite radio tuner (1F1)*1
    Stereo component amplifier assembly (440)*2
    Stereo Component Amplifier Power Source Circuit (Click here)
    Television display assembly (1BO)*3
    Television Display Power Source Circuit (Click here)
    1. *1: w/ Satellite Radio
    2. *2: w/ Stereo Component Amplifier
    3. *3: w/ Rear Seat Entertainment System


NEXT


3.INSPECT RADIO RECEIVER ASSEMBLY


    E145834E24
  1. Disconnect the K4* and K22 radio receiver assembly connectors.

    1. *: w/ Stereo Component Amplifier

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K4-5 (ATX+) - K4-15 (ATX-)*
    Always
    60 to 80 Ω
    K22-9 (TXM+) - K22-10 (TXM-)
    Always
    60 to 80 Ω

    1. *: w/ Stereo Component Amplifier
    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE RADIO RECEIVER ASSEMBLY (Click here)

C
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
A


4.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to Terminals of ECU (Click here).

  1. Referring to the wiring diagram, check the AVC-LAN circuit between the multi-media interface ECU and component shown by the sub-code.

    1. Disconnect all connectors between the multi-media interface ECU and component shown by the sub-code.

    2. Check for an open or short in the AVC-LAN circuit between the multi-media interface ECU and component shown by the sub-code.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

END