POWER DOOR LOCK CONTROL SYSTEM > Driver Side Door Lock Motor Circuit |

| 1.INSPECT FRONT DOOR LOCK MOTOR ASSEMBLY LH |
![]() |
Remove the front door lock motor LH.
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 (L) Battery negative (-) → Terminal 1 (UL) | Lock |
| Battery positive (+) → Terminal 1 (UL) Battery negative (-) → Terminal 4 (L) | Unlock |
| Result | Proceed to |
| OK | A |
| NG (for Double Cab) | B |
| NG (for Regular Cab) | C |
| NG (for CrewMax) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK MOTOR LH - MAIN BODY ECU) |

Disconnect the N4 door lock connector.
Disconnect the DD and J4 ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N4-4 (L) - DD-3 (ACT+) | Always | Below 1 Ω |
| N4-1 (UL) - J4-5 (ACTD) | ||
| DD-3 (ACT+) - Body ground | Always | 10 kΩ or higher |
| J4-5 (ACTD) - Body ground |
|
| ||||
| OK | ||
| ||