Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR (for CrewMax)

SIDE AIRBAG SENSOR (for CrewMax) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side)


    B165648E02
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT UPPER ARMREST BASE PANEL LH (for Front Side)


    B166211
  1. Using a screwdriver, detach the 2 clips and front armrest upper base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



5. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH (for Front Side)


    B168274E01
  1. Detach the 3 clips and remove the door lower frame bracket garnish.



6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side)


    B166215E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 9 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



7. REMOVE FRONT SIDE AIRBAG SENSOR


    B166953
  1. Disconnect the connector.

  1. Remove the screw and side airbag sensor.



8. REMOVE REAR SEAT ASSEMBLY (for Rear Side)
  1. Remove the rear seat (Click here).



9. REMOVE REAR DOOR SCUFF PLATE LH (for Rear Side)


B165842
  1. Detach the 6 claws and 2 clips, and remove the rear door scuff plate.



10. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Rear Side)


11. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH (for Rear Side)


B165830
  1. Detach the 2 claws and remove the cover.



    B165831
  1. Loosen the bolt and disconnect the outer lap belt anchor.



    B165832
  1. Detach the 6 clips and remove the lower quarter trim panel.



12. REMOVE REAR SIDE AIRBAG SENSOR


    B166508
  1. Remove the bolt and side airbag sensor.

  1. Disconnect the connector.