Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION ANTENNA

NAVIGATION ANTENNA > REMOVAL

for Preparation Click here



1. REMOVE PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. for Column Shift Type:
    Remove the instrument panel (Click here).

  1. for Floor Shift Type:
    Remove the instrument panel (Click here).



4. REMOVE NO. 1 HEATER TO REGISTER DUCT WITH NO. 2 HEATER TO REGISTER DUCT


  1. Remove the 5 screws and duct.


    B161141



5. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B160598
  1. Remove the 2 screws.

  1. Detach the claw and remove the duct.



6. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    B160599
  1. Remove the 2 screws.

  1. Detach the claw and remove the duct.



7. REMOVE DEFROSTER NOZZLE ASSEMBLY


    B160597
  1. Remove the 3 screws and nozzle.



8. REMOVE NAVIGATION ANTENNA ASSEMBLY
  1. Detach the clamp.



  1. Remove the 2 screws and antenna.


    B164817