Home › DRIVE LINE › JF1A TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Touch select 2-4 and high-low system 
Symptom
Suspected Area
See page
Switch from 2WD to 4WD HIGH impossible (Only 4HI indicator light, or 4HI and 4LO indicator lights blink at 0.2 second intervals)
Harness or connector
Click here
Transfer shift actuator
Click here
A.D.D. actuator
Click here
CAN communication system
Click here
4WD control switch
Click here
4WD control ECU
Click here
Transfer
Click here
Switch from 4WD HIGH to 4WD LOW impossible (Only 4LO indicator light, or 4HI and 4LO indicator lights blink at 0.2 second intervals)*
Harness or connector
Click here
Transfer shift actuator
Click here
CAN communication system
Click here
4WD control switch
Click here
4WD control ECU
Click here
Transfer
Click here
Switch from 4WD HIGH to 2WD impossible (4HI and 4LO indicator lights blink at 0.2 second intervals)
Harness or connector
Click here
Transfer shift actuator
Click here
A.D.D. actuator
Click here
CAN communication system
Click here
4WD control switch
Click here
4WD control ECU
Click here
Transfer
Click here
Switch from 4WD LOW to 4WD HIGH impossible (Only 4LO indicator light, or 4HI and 4LO indicator lights blink at 0.2 second intervals)
Harness or connector
Click here
Transfer shift actuator
Click here
CAN communication system
Click here
4WD control switch
Click here
4WD control ECU
Click here
Transfer
Click here
4HI indicator light does not come on
Harness or connector
Click here
4WD fuse
Click here
Combination meter
Click here
CAN communication system
Click here
4WD control switch
Click here
4WD control ECU
Click here
4HI indicator light remains on
4WD control switch
Click here
4WD control ECU
Click here
Combination meter
Click here
4LO indicator light does not come on
Combination meter
Click here
4WD control switch
Click here
4WD control ECU
Click here
4HI indicator light remains on
4WD control switch
Click here
4WD control ECU
Click here
Combination meter
Click here

HINT:
*: Blinking during the return control is not a malfunction.