Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Fuel Receiver Gauge Malfunction

for Preparation Click here


DESCRIPTION

The fuel sender gauge has a variable resistance mechanism. The resistance decreases when the fuel amount increases, and the resistance increases when the fuel amount decreases. The fuel receiver gauge changes based on the resistance of the fuel sender gauge.

WIRING DIAGRAM


B166182E01


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1500 is not output
    A
    DTC B1500 is output
    B



B
Go to DTC B1500 (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (FUEL RECEIVER GAUGE)
  1. Operate the Techstream according to the steps on the display and select "Active Test" (Click here).

    OK:
    Needle indication is normal.


    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Fuel Meter Operation
    Fuel receiver gauge
    EMPTY, 1/2 or FULL
    -



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)