DTC B15BB Multi-media Interface ECU Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B15BB | When one of the conditions below is met:
|
|

| 1.REPLACE "iPod" OR USB DEVICE |
Disconnect the USB device or "iPod" from the stereo jack adapter.
Turn the ignition switch off.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter.
| NEXT | |
| 2.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 3.RECHECK DTC |
Recheck DTCs and check if the same DTC occurs again.
|
| ||||
| OK | ||
| ||
| 4.INSPECT MULTI-MEDIA INTERFACE ECU |
![]() |
Disconnect the J100 No. 1 stereo jack adapter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J100-1 (UP1) - J100-4 (UJSG) | Always | 5 V |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - STEREO JACK ADAPTER) |
![]() |
Disconnect the J116 multi-media interface ECU connector.
Disconnect the J100 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J116-1 (UESG) - J100-1 (UP1) | Always | Below 1 Ω |
| J116-4 (UDO) - J100-4 (UJSG) | Always | Below 1 Ω |
| J116-1 (UESG) - Body ground | Always | 10 kΩ or higher |
| J116-4 (UDO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||