Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Mute Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU

for Preparation Click here


DESCRIPTION

The navigation receiver assembly controls the volume according to the MUTE signal from the stereo component tuner assembly.
The MUTE signal is sent to reduce noise and a popping sound generated when switching the mode etc. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the navigation receiver assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM


E190161E12


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY


    E176580E16
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K8-6 (MUTE) - Body ground
    Ignition switch ACC, Satellite radio playing → Changing source
    Above 3.5 V → Below 1 V



NG
Go to step 2
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - MULTI-MEDIA INTERFACE ECU)


    E191672E01
  1. Disconnect the K8 navigation receiver assembly connector.

  1. Disconnect the J107 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K8-6 (MUTE) - J107-6 (MUT1)
    Always
    Below 1 Ω
    K8-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)